The fields with the red border are required.
    www.thecementgrindingoffice.com
    All rights reserved © 2012-2015 The Cement Grinding Office
      VOLUME LOAD - Monochamber Mill    
      This calculator gives the volume load (or filling degree in %) after measurements  
      inside the mill      
      H/D measurement method:      
      Date    
      Company/Plant
      Mill N°  
      Shell diameter m  
      Internal diameter m  
      Measured height H1 (*) m  
      Measured height H2 (*) m  
      Measured height H3 (*) m  
      Average height H m  
      H/D     
      Volume load %  
     
      Useful length m  
      Tonnage t  
      (*) See where are H1, H2 and H3 on the sketch below  
     
     
     
       
       
       
       
       
       
       
       
       
       
       
    www.thecementgrindingoffice.com
     
     
     
       
       
       
       
       
       
       
       
       
       
       
       
       
       
       
     
     
     
       
       
       
       
       
       
       
       
       
       
       
       
       
     
     
     
       
       
       
       
       
       
       
       
       
       
       
       
       
       
       
       
       
       
    www.thecementgrindingoffice.com
      Visible plates method:      
      Shell diameter m  
      Internal diameter m  
      Total number of plates    
      Visible number of plates at inlet  
      Visible number of plates at middle  
      Visible number of plates at outlet  
      Visible number of plates average  
      Angle θ degrees  
      Angle θ radians  
      Height H m  
      H/D    
      Volume load %  
     
      Useful length m  
      Tonnage t  
      Central part measurement method:      
      Shell diameter m  
      Internal diameter m  
      Inlet:      
      Central part diameter mm (inlet trunnion)  
      Distance to top of balls (*) mm (from top of central part)  
      Height H inlet m  
      Outlet:       
      Central part diameter mm (outlet trunnion or diaphragm)  
      Distance to top of balls (*) mm (from top of central part)  
      Height H outlet m  
      Height H average m  
      Volume load %  
     
      Useful length m  
      Tonnage t  
    www.thecementgrindingoffice.com
    All rights reserved © 2012-2015 The Cement Grinding Office